The square you lay crossways across the keystock and use the vertical arm hanging down, to sight against the vise jaws.
You'll use these to check your filing progress on the top of the keystock. Best if you have a straightedge and a small square. Put the barreled action in a vise, as straight and level as possible. Without a milling machine, you'll have to use the Nicholson mill via draw filing. Depending upon the size keystock you used, you may want to reduce the height of it. Then narrow the keystock by filing so it snugs down into the entire length of the sightbase, just fitting in between the ears the ladder pivot goes through.ĭrill a hole crossways through the ears on the sightbase, (using the ladder pivot holes) and your piece of keystock and drive in a rollpin. You can readily see it in the sight alteration photo's in my "Turk That Should Have Been" thread. File in the wedge on the keystock that fits back into the rear end of the sight base. Remove the ladder and the elevation wings.
Junior, get a piece of keystock to fit in the rear sight base.
0 kommentar(er)
